supply of lathe all geared head stock ss and sc - height of the centre over the bed 150mm, length of bed 4.5 feet, width of the bed greater or equal 240mm,distance between centres 1000mm, spindle -a-2-4-cam lock(d-1)legs are heavy duty, minimum weight of the machine greater than 800kg with complete accessories, such as 1)coolant pump 2) splash guard 3) driving plate with drivers 4) face plate 5) 3 and 4 jaw chucks 6) taper turning attachment 7) travel steady, fixed steady 8)line and dead centres 9) square indexable (45 degree) tool post , 10) driving dogs - straight and bent tail, electric - suitable motor connected with suitable dol starter, forward and reverse rotor switch and lamp fitting with manual, other accessories a) coolant equipment with pump and motor confirming to is 2161-1996 (reaffirmed 2006) and is 1996-1979 (reaffirmed 2007) edition 3-3 b) suitable lubrication system for the various rotating and sliding components as per is 11118-1997(reaffirmed 2006) c) one set of servicing tools(enclosed complete list with sizes, qty, against each) d) the machine guide ways shall have surface hardness between 45 to 50 hrc wherever hardened steel strips are provided on the guide surfaces, the minimum hardness shall be of 55 hrc,machine without hardened guideways are not acceptable, bed hardness minimum 390bhn e) power factor shall be not less than 0.9 as per is-7752 the following shall constitute acceptance test reports, 1) test accuracy as per is 1878 (part 1-1993 reaffirmed 2004) or is 1879(part 2-1992 2) hardness of the bed 3) hardness of the guide ways 4) positional accuracy test 5) geometrical accuracy test 6) electrical test machine drawing and electrical circuit diagram should be provided, suitable anti vibration mount should be provided
